To: (Separate email addresses with commas)
From: (Your email address)
Message: (Optional)
Send
Cancel

Thanks!

Close

Quiz: Can You Fly The RNAV (GPS) Y RWY 5L Into Raleigh-Durham?

Boldmethod

Are you ready for your next GPS approach? Take this quiz and find out.


  1. 1) Why is the missed approach point RW05L circled, and SCHOO is not?
    View FAA Chart

    Waypoints that are circled are mandatory fly-over points, whereas waypoints like SCHOO and WEPAS are fly-by points. With fly-by points like SCHOO, your GPS will use turn anticipation to 'cut the corner' to make a smooth turn onto the next course. However, in the event of a missed approach, your GPS will assure that you'll cross directly over the missed approach fly-over point.

    Waypoints that are circled are mandatory fly-over points, whereas waypoints like SCHOO and WEPAS are fly-by points. With fly-by points like SCHOO, your GPS will use turn anticipation to 'cut the corner' to make a smooth turn onto the next course. However, in the event of a missed approach, your GPS will assure that you'll cross directly over the missed approach fly-over point.

  2. 2) In the profile view, it says that the VGSI and RNAV glidepath are not coincident. What does this mean?
    View FAA Chart

    VGSI, or Visual Glide Slope Indicator, will not match up with the glidepath when you break out of IMC. Be aware that you may not initially have 2 white and 2 red PAPIs when transitioning from instrument to visual flying.

    VGSI, or Visual Glide Slope Indicator, will not match up with the glidepath when you break out of IMC. Be aware that you may not initially have 2 white and 2 red PAPIs when transitioning from instrument to visual flying.

  3. 3) You are in a plane equipped with an AP/FD (both inoperative). ATC has you proceed direct SCHOO and tells you that simultaneous approaches to runways 5L and 5R are in effect. Can you fly this approach?
    View FAA Chart

    In the header, it states that in order to fly this approach with simultaneous operations, the use of an FD or AP is required. In this case, with both of these inoperative on your aircraft, you cannot accept this approach.

    In the header, it states that in order to fly this approach with simultaneous operations, the use of an FD or AP is required. In this case, with both of these inoperative on your aircraft, you cannot accept this approach.

  4. 4) If you fly the approach using the LPV line of minimums, how high above the touchdown zone elevation (TDZE) will you be when you reach decision altitude?
    View FAA Chart

    You will be 214' above the touchdown zone elevation, which is the highest point in the first 3,000' of the runway.

    You will be 214' above the touchdown zone elevation, which is the highest point in the first 3,000' of the runway.

  5. 5) Looking at the airport sketch, what is indicated by the white dots on runways 5L and 5R?
    View FAA Chart

    This indicates that this runway has centerline lighting.

    This indicates that this runway has centerline lighting.

Well...that could have gone better.

You scored %. Time for some studying!

Share on Facebook Share on Twitter
Pic

That was a little bumpy...but not bad.

You scored %. Time for a quick refresher.

Share on Facebook Share on Twitter
Pic

Nailed it!

You scored %. Well done.

Share on Facebook Share on Twitter
Pic
RNAV-(GPS)-Y-RWY-5L X

Corey Komarec

Corey is an Airbus 320 First Officer for a U.S. Major Carrier. He graduated as an aviation major from the University of North Dakota, and he's been flying since he was 16. You can reach him at corey@boldmethod.com.

Images Courtesy:

Recommended Stories

Latest Stories

    Load More
    Share on Facebook Share on Twitter Share via Email