To: (Separate email addresses with commas)
From: (Your email address)
Message: (Optional)
Send
Cancel

Thanks!

Close

5 Rules-Of-Thumb You Can Use On Your Next Flight

This story was made in partnership with AOPA. Ready to join the largest aviation community in the world? Sign up and become an AOPA Member today.

Flying gets a lot easier once you know some basic rules-of-thumb. Here are 5 of the best rules, and how to use them.

1) Calculating Glideslope Descent Rates

If you're flying a 90-knot approach speed on a 3-degree glideslope, you'll need to descend at roughly 450FPM to maintain the glideslope. But how did we come up with that?

There's a pretty easy rule-of-thumb to figure that descent rate out. Divide your ground speed by 2, then add a 0 to the end. So if you take 90 knots / 2, you get 45. Add a zero to the end, and you get 450 FPM. There's another way to approximate this. You can also multiply your groundspeed by 5 and you'll get an approximate descent rate for a 3-degree glideslope.

Boldmethod

2) More Descent Calculations

At a 1 degree angle of descent, for every 1 mile you fly, you'll descend 100 feet. This ratio can be used to determine other aspects of descent. For instance, if you have 1 mile to descend 600 feet, you'll need a 6-degree descent.

While you may be able to chop and drop in a C172, a larger jet or turboprop usually can't do that. Plus, it's not safe. Try your best to plan a 3-degree arrival into all of your airports for the safest and most gentle descent.

Boldmethod

3) Course Corrections

The 1 in 60 rule states that if you're off course by 1NM after 60 miles flown, you have a 1-degree tracking error. Time to correct that heading!

Another tip: If you're 60 miles away from a VOR, and you're off course by one degree, you're off course by one mile. Last thing: if you fly a 60-mile arc around the VOR, you'd fly a total of 360 miles...talk about a long instrument approach!

Boldmethod

5) How To Calculate Windshear

Rule-of-thumb: the total shear is double the peak wind. If the outflow speed of a microburst is 30 knots, you'll experience about 60 knots of shear as you cross the microburst. And it all can happen in a very short period of time.

Think about what would happen to your Cessna 172 if you went from 100 knots to 40 knots in the matter of a few seconds...

Boldmethod

6) Flying Gusty Approaches

In gusty conditions, add half of the gust factor to your approach speed. If your final approach speed is 80 knots, and the winds have a gust factor of 20 knots (for example, winds 10 gusting to 30), fly the approach at 90 knots.

Boldmethod

What other rules of thumb do you use? Tell us in the comments below.


Ready to join the largest aviation community in the world? Sign up and become an AOPA Member today.


Images Courtesy:

Recommended Stories

Latest Stories

    Load More
    Share on Facebook Share on Twitter Share via Email