To: (Separate email addresses with commas)
From: (Your email address)
Message: (Optional)
Send
Cancel

Thanks!

Close

5 Rules-of-Thumb You Can Use On Your Next Flight

Boldmethod

1) Estimating Your Crosswind Component

When you're on the ground, it's easy to use the crosswind chart in your POH, or an E6B. But when you're in the air, neither of those options are very practical.

Lucky for all of us, there's an easier way. If the wind is 30 degrees off the runway, your crosswind component is about 50% of the wind speed.

If the wind is 45 degrees off the runway, the crosswind component is about 75% of the wind speed.

And if the wind is 60 degrees or more off the runway, the crosswind component is roughly the same as the total wind.

Boldmethod

2) 10% Weight Increase = 20% Takeoff and Landing Distance Increase

The more weight you have, the more runway you need. And while this rule is far from exact, it gets you in the ball park for a normally aspirated plane.

Obviously, when it comes time to calculate your actual performance, you'll want to pull out your POH.

Boldmethod

3) Takeoff roll increases about 10% for every additional 1,000 feet of density altitude

For most normally-aspirated airplanes, you add about 10% of takeoff roll distance for every 1,000' of density altitude (DA).

For example, in Denver, with an increase of 3,200' of density altitude, you'd increase your takeoff roll by about 32%.

So if you have a 1,500' takeoff roll on a standard day in Denver (3 degrees C), you'll increase that roll to almost 2,000' on a 30C day.

Boldmethod

4) When Should You Start Your Descent?

3 degrees is a comfortable descent rate in just about any aircraft. But when you're approaching an airport, how do you know when to start down?

Divide the altitude you need to lose by 300.

For example, if you're at 11,000', and you need to get down to a pattern altitude of 2,000', you need to descend 9,000'.

9,000/300 = 30 miles.

If you start a 3-degree descent 30 miles out, you'll hit pattern altitude as you reach the airport. Keep in mind, you'll want to add a few miles on to your number, so you hit pattern altitude slightly before you get to the airport.

Boldmethod

5) ILS Course Width

VFR pilots can make good use of the ILS too. Whether it's a dark moonless night, or a long straight-in on a hazy day, following the ILS to your runway keeps you safe from terrain and obstructions (not to mention, you know you're lined up with the right runway).

The closer you get to the runway, the more sensitive the signal is. As you cross the threshold, 1/2 dot deflection on the localizer = about 1/2 the runway width. So if you're a half dot off as you approach the runway, you're going to be looking at the runway edge lights.

Boldmethod

What are other rules-of-thumb do you use? Tell us in the comments below.

Colin Cutler

Colin Cutler

Colin is a Boldmethod co-founder and lifelong pilot. He's been a flight instructor at the University of North Dakota, an airline pilot on the CRJ-200, and has directed the development of numerous commercial and military training systems. You can reach him at colin@boldmethod.com.

Images Courtesy:

Recommended Stories

Latest Stories

    Load More
    Share on Facebook Share on Twitter Share via Email